Similar to High transparency acrylic PX521

3. Vacuum Casting Process

1). Pre-degassing

Remix POLYOL before each weighing. Degas each part before use. 2).Temperature of resin

If in the low temperature storage, the work will be A and B two liquid heating to 20  ℃ .The higher, the liquid temperature, the shorter is the pot life and the lower, the liquid temperature, the longer  is the pot life. Extremely too low temperatures may cause insufficient mixing and improper

curing.

3).Mold temperature

Keep the temperature of silicone mold to 60~70℃ in advance. Too low mold temperatures may cause improper curing to result in lower physical properties.  Mold temperatures should  be controlled precisely as they affect the dimensional accuracy of the finished article.

4).Casting

Degas  under vacuum for 5-10minutes,  Mix for approximately two  minutes,  cast  in a  mold pre-heated at 70°C minimum.

5). Curing condition

Allow to cure 120 minutes for 10mm thickness at 70°C before demolding.

4. Precautions in handling

1). As both A and B components are sensitive to water, don't allow water get into material or don't allow moisture in the air come into prolonged contact with the material. Close container tight after use.

2) Penetration of water into A component may lead to generation of much air bubbles in the cured product. If this should happened, we recommend to heat A component to 60℃-70℃ and degas it under vacuum for about 30 minutes.

3) ．B component in part or in whole may freeze when it is stored for longer period of time at temperatures below 5℃ . Frozen material can be used after melting. Warm up container to 60 ~70℃ for 1~2 hours and use the material after stirring it well.

4) ．When B component is stored in a frozen state, it deteriorates more quickly on age than a liquid material. We recommend to melt it completely and store at 20~25℃ .

5. Precautions in Safety and Hygiene

1). ensure good ventilation

2). wear glove. Take care that hands or skin are not coming in direct contact with raw materials. In case of contact, wash with soap and water immediately.    It may irritate hands or skin if they are left in contact with raw materials for longer period of time.

3). wear safety glasses. If raw materials get into eyes, rinse with flowing water for 15 minutes and call a doctor.

4). Install duct for vacuum pump to ensure that air is exhausted to the outside of the work shop.

6. STORAGE CONDITIONS

Shelf life is 12 months in a dry place and in the original unopened containers at a temperature between 15 and 25°. Any opened container must be tightly closed under a dry gas blanket.

7. Delivery For

A Component: 0.66kg tin can.               B Component: 1kg tin can.